Back to homepage

Hands-on

Answers: MLPPP 2

Answers: MLPPP 2

🕔09:10, 14.Oct 2016

This lab asks you to do a basic migration: move from using two parallel serial links as independent links to instead treating them as one layer 3 link using MLPPP. This lab requires new configuration as well as analysis of

Read Full Article
Multilink PPP 2

Multilink PPP 2

🕔09:05, 12.Oct 2016

Multilink PPP (MLPPP) makes multiple parallel links act like one link from a layer 3 perspective. In this next lab, the lab begins with a working configuration that does not use MLPPP, with two parallel serial links between two routers.

Read Full Article
Answers: IPv6 Extended ACLs 1

Answers: IPv6 Extended ACLs 1

🕔09:10, 7.Oct 2016

This latest lab breaks the config lab mold just a tad, but for a good reason. It looks like a straightforward config lab, requiring just 10 minutes or so to do on paper. But it sets you up for one

Read Full Article
IPv6 Extended ACLs 1

IPv6 Extended ACLs 1

🕔09:05, 5.Oct 2016

Are you comfortable matching packets with extended IPv6 ACLs? How about with TCP and UDP ports in those ACLs? Here’s a 10-minute lab exercise to practice; all you need is the time and a piece of paper or a place

Read Full Article
Answers: Local SPAN 2

Answers: Local SPAN 2

🕔09:10, 30.Sep 2016

Configuring local SPAN does not take a lot of commands. The bigger danger is capturing too much, which risks losing some of the messages and also causing you more work to see the content that you want to see. As

Read Full Article
Local Span 2

Local Span 2

🕔09:05, 28.Sep 2016

One of many reasons to use the Switched Port Analyzer (SPAN) feature is a Cisco switch is to copy frames out a port that connects to a network analyzer (like Wireshark). Wireshark can then analyze the messages so that you

Read Full Article
Answers: SNMPv3 2

Answers: SNMPv3 2

🕔09:10, 23.Sep 2016

This lab asks you to use both authentication and privacy with SNMPv3, so it takes a few longer commands compared to some SNMP configurations. Focus on the basics, because there are many basics with SNMPv3 configuration. Especially for this lab,

Read Full Article
SNMPv3 2

SNMPv3 2

🕔09:05, 21.Sep 2016

In real life, you will probably configure SNMP correctly, use a similar configuration on all routers and switches, and then forget the details of how to configure all the other possible options. For the CCNA R&S exams, it helps to

Read Full Article
Answers: MLPPP 1

Answers: MLPPP 1

🕔09:10, 15.Sep 2016

Configuring multilink PPP (MLPPP) uses a large number of commands for a single feature. However, many of the commands are repetitive on several interfaces. The trick is to figure out which commands are repeated on both the physical and multilink

Read Full Article
Multilink PPP 1

Multilink PPP 1

🕔09:05, 13.Sep 2016

Multilink PPP (MLPPP) makes multiple parallel links act like one link from a layer 3 perspective. Then, when a router’s layer 3 routing decides to forward a layer 3 packet out the layer 3 MLPPP multilink interface, the router has

Read Full Article

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Search

Categories