Answers: SNMPv2c Secured with ACLs

Answers: SNMPv2c Secured with ACLs

🕔13:10, 29.Jul 2016

This latest lab lets you practice configuring SNMP. At the same time, it lets you configure restrictions so that only some devices are allowed to even use SNMP with the routers in the lab. Check out the lab requirements first,

Read Full Article
SNMPv2c Secured with ACLs

SNMPv2c Secured with ACLs

🕔13:05, 28.Jul 2016

#CCNA candidates can struggle with SNMP configuration for a couple of reasons. First, in real life, you configure SNMP on each device and then ignore the configuration. Because of that, when you do have to configure it, most of us

Read Full Article
Answers: PAP 1

Answers: PAP 1

🕔13:10, 26.Jul 2016

Did you remember how to configure PAP on a serial link? Time to check your config for a back-to-back serial link with PPP and PAP. Check out the requirements back in the lab post, create your answers, and come back

Read Full Article
PAP 1

PAP 1

🕔13:05, 25.Jul 2016

Getting reps with connecting two router serial interfaces helps build confidence. This lab gives you another chance, this time with PAP authentication on the link. The goal: get the link working so both routers can ping each other.

Read Full Article
Answers: GRE Tunnel 3

Answers: GRE Tunnel 3

🕔13:10, 22.Jul 2016

You know the drill. Do the lab, come here to check your answer. This one is on configuring a point-to-point GRE tunnel, using a hostname for the tunnel destination, and with OSPF interface thrown in for some quick review.

Read Full Article
GRE Tunnel 3

GRE Tunnel 3

🕔13:05, 21.Jul 2016

This latest lab requires you to configure a point-to-point GRE tunnel, but with no encryption config. Unless this is your first Config Lab, you know the drill. If not: take 5-10 minutes now, read the lab, and type your answer

Read Full Article
Answers: PPP over Ethernet 2

Answers: PPP over Ethernet 2

🕔13:10, 20.Jul 2016

Creating a PPPoE configuration requires some practice, so do the lab on your own, and check your answers here. More importantly, find a place to do this lab on gear (or VIRL) or a simulator, and spend the time doing

Read Full Article
PPP over Ethernet 2

PPP over Ethernet 2

🕔13:05, 19.Jul 2016

Configuring PPPoE may seem scary, but it is not too hard from a practical sense. The complex part is understanding each command, and the even more complex part is connecting the configuration to the underlying ideas shown in the related

Read Full Article
Answers: L2 EtherChannel 2

Answers: L2 EtherChannel 2

🕔13:10, 8.Jul 2016

This latest lab asks you to configure layer 2 EtherChannels, but starting with a partial configuration already. Go back and check the lab exercise, create your answer, and check your answer here.

Read Full Article
L2 EtherChannel 2

L2 EtherChannel 2

🕔13:05, 7.Jul 2016

Both layer 2 EtherChannel and layer 3 EtherChannel use the same set of commands to create the channel, either through static configuration or using a dynamic protocol (LACP or PAgP). Today’s lab provides a little exercise on all three options

Read Full Article

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Search

Categories