Predicting ARP Messages 1

CCENTSkills
By CCENTSkills January 31, 2018 09:05

#CCNA candidates learn about ARP early in the ICND1 half of their studies, and it takes just a few minutes to learn the basics. At the same time, people who write CCNA exam questions can ask us about ARP in many ways that require us to think about ARP in the context of many other networking concepts. You need to be ready to take that basic knowledge and answer these kinds of applied ARP questions – and here’s a sample.

Question

In quick succession, host A successfully pings host B, the engineer clears the MAC table on switch SW2, and host A again successfully pings host B. Which answers describe the ARP Requests sent as a result of the second ping?

  1. 1 ARP Request is sent by hosts A and B combined
  2. 2 or more ARP Requests are sent by hosts A and B combined
  3. 1 ARP Request is sent by switches SW1 and SW2 combined
  4. 2 or more ARP Requests are sent by switches SW1 and SW2 combined
  5. 1 ARP Request is sent by routers R1 and R2 combined
  6. 2 or more ARP Requests are sent by routers R1 and R2 combined
  7. 0 ARP Requests are sent

As usual, I’ll post the answer in just a few days. At that time, a link to the answer will appear towards the bottom of this page, just above where the comments begin.

Answer: Forwarding and Encapsulation
Answer: Predicting ARP Messages 1
CCENTSkills
By CCENTSkills January 31, 2018 09:05
Write a comment

3 Comments

  1. ciscoccna January 31, 10:13

    Hello mister Odom …I guess the Answer is B.

    Reply to this comment
  2. CYRIL February 1, 18:47

    G

    Reply to this comment
  3. Jack Mac February 10, 14:36

    ARP is used by devices at Layer 3, so the switches would not be issuing ARP requests.
    The host devices rely upon their individual ARP caches, and the routers also rely upon individual ARP caches before issuing any ARP requests. Since no ARP caches have been cleared, these devices will not be issuing ARP requests.
    What will happen as a result of of the MAC table being cleared? Switch 2 will need to flood the incoming ICMP Echo Request out ALL ports except the port, G0/1, that is tied to R2 since it won’t know where the MAC address for host B “lives”.
    The answer to the question, as noted by CYRIL, is G – 0 ARP requests will be sent.

    Reply to this comment
View comments

Write a comment

Your e-mail address will not be published.
Required fields are marked*

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Thank you for subscribing.

Something went wrong.

Search

Categories