Back to homepage

100-105 Part 5: IPv4 Routing

Answers: Layer 3 Switching 1

Answers: Layer 3 Switching 1

🕔09:10, 20.Jul 2016 This lab asks you to configure layer 3 switching, a little trunking, and some VLANs. The lab is long enough to forget all the requirements before you finish, so I would suggest keeping the lab post open in a tab Read Full Article
Layer 3 Switching 1

Layer 3 Switching 1

🕔09:05, 18.Jul 2016 This next lab asks you to enable layer 3 switching in a couple of distribution layer switches. This lab is pretty far reaching as well, asking for some VLAN trunking configuration and VLAN creation. Because it is such a comprehensive Read Full Article
Answers: RIPv2 Basics 2

Answers: RIPv2 Basics 2

🕔09:10, 14.Jun 2016 Once you have read through the book’s material for RIPv2, it should only take two or three good RIP labs to get comfortable with RIP configuration. This latest lab should help you with that bit of practice. You know the Read Full Article
RIPv2 Basics 2

RIPv2 Basics 2

🕔09:05, 13.Jun 2016 RIP Version 2 (RIPv2) configuration requires the use of network command to indirectly enable RIP on router interfaces. This lab asks you to configure RIP by choosing the correct parameters for the RIPv2 network command, please consider a few other Read Full Article
Answers: RIPv2 Options 1

Answers: RIPv2 Options 1

🕔09:10, 9.Jun 2016 Know how to limit the number of RIP routes to each destination? How to enable RIP on an interface – but to not send Update messages out that interface? How to make RIP not summarize routes for classful networks? The Read Full Article
RIPv2 Options 1

RIPv2 Options 1

🕔09:05, 8.Jun 2016 It's baaack... RIPv2 is back, and in the new ICND1 book per the new ICND1 100-105 exam topics announced May 2016. The book's out now. RIP Version 2 (RIPv2) configuration requires a series of RIP network commands, but it also Read Full Article
Answers: RIPv2 Basics 1

Answers: RIPv2 Basics 1

🕔09:10, 26.May 2016 For this lab, your job is to take a working IPv4 network that has no routing protocol yet and add the RIPv2 configuration. As usual, check out the lab requirements here and take your shot at the configuration. Then check Read Full Article
RIPv2 Basics 1

RIPv2 Basics 1

🕔09:05, 25.May 2016 RIP Version 2 (RIPv2) configuration may be one of those topics that become obvious with a little practice, but it does require a little practice at least. Interestingly, you may have to think more about which routers do not need Read Full Article
Answers: IPv4 Static Routes 1

Answers: IPv4 Static Routes 1

🕔09:10, 10.May 2016   The configuration for this latest lab is relatively simple. However, it definitely helps you solidify your understanding of IPv4 routing, and that is something you should definitely master along the way. As always, start by checking on the lab Read Full Article
IPv4 Static Routes 1

IPv4 Static Routes 1

🕔09:05, 9.May 2016 One of the best ways to learn IPv4 routing is to think hard about IPv4 static routes. Today’s lab gives you more of that with a typical config lab. It starts with a topology and with IPv4 addresses configured. Your Read Full Article

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Thank you for subscribing.

Something went wrong.

Search

Categories