Back to homepage

Config Lab 200-301

CLI Miscellany 1

CLI Miscellany 1

🕔09:05, 1.Aug 2016 The CCENT and CCNA R&S certifications include many prominent features that need to be configured. VLANs. Trunking. Routing protocols. IPv4 addressing. IPv6 addressing. But there are also the occasional small topic or single command that might be forgotten. This lab Read Full Article
NTP Client/Server 1

NTP Client/Server 1

🕔09:05, 1.Aug 2016   NTP makes me think of old spy novels and movies, where the team would set their analog watches to the same time, and say something like “On my mark, it will be 9:55… mark!”. NTP uses other mechanisms, of Read Full Article
Answers: IPv6 Static Route 2

Answers: IPv6 Static Route 2

🕔09:10, 27.Jul 2016   Static IPv6 routes may seem like a bigger challenge than static IPv4 routes at first. Configuring static IPv6 routes, however, can really help you learn those basic routing concepts. Check out the lab requirements, get some reps in, and Read Full Article
IPv6 Static Route 2

IPv6 Static Route 2

🕔09:05, 25.Jul 2016   IPv6 routing has many similarities with IPv4 routing; however, the length of the IPv6 addresses can sometimes get in the way of learning the main concepts. This next lab removes those barriers with a straightforward IPv6 static route configuration Read Full Article
Answers: IPv6 EUI-64 Addressing 1

Answers: IPv6 EUI-64 Addressing 1

🕔09:10, 23.Jul 2016 This lab requires a fair bit of manipulating hexadecimal numbers to reverse engineer the values you need to configure in the lab; however, it serves as good exercise to make sure you understand how to configure IPv6 addresses using the Read Full Article
IPv6 EUI-64 Addressing 1

IPv6 EUI-64 Addressing 1

🕔09:05, 21.Jul 2016 Do you know how to take an interface MAC address and determine what IPv6 address the interface would use when using EUI-64? Could you then do the reverse: take the IPv6 address, and predict what MAC address is used for Read Full Article
Answers: Layer 3 Switching 1

Answers: Layer 3 Switching 1

🕔09:10, 20.Jul 2016 This lab asks you to configure layer 3 switching, a little trunking, and some VLANs. The lab is long enough to forget all the requirements before you finish, so I would suggest keeping the lab post open in a tab Read Full Article
Layer 3 Switching 1

Layer 3 Switching 1

🕔09:05, 18.Jul 2016 This next lab asks you to enable layer 3 switching in a couple of distribution layer switches. This lab is pretty far reaching as well, asking for some VLAN trunking configuration and VLAN creation. Because it is such a comprehensive Read Full Article
Answers: PAT w/ a Pool 1

Answers: PAT w/ a Pool 1

🕔09:10, 13.Jul 2016 Configuring #PAT with a pool has it all as far as NAT is concerned. Exercise your memory and skills, and as always, find a place to try it out if you can. (This config may have the command with the Read Full Article
PAT w/ a Pool 1

PAT w/ a Pool 1

🕔09:05, 11.Jul 2016 Configuring #PAT with a pool of inside global addresses combines most everything you can possibly configure with NAT in a Cisco router. Take a look at the requirements in this latest lab and put together your own configuration, with a Read Full Article

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Thank you for subscribing.

Something went wrong.

Search

Categories