Back to homepage

Config Lab CCNA Vol 2 Part 3

Answers: SNMPv3 2

Answers: SNMPv3 2

🕔09:10, 23.Sep 2016

This lab asks you to use both authentication and privacy with SNMPv3, so it takes a few longer commands compared to some SNMP configurations. Focus on the basics, because there are many basics with SNMPv3 configuration. Especially for this lab,

Read Full Article
SNMPv3 2

SNMPv3 2

🕔09:05, 21.Sep 2016

In real life, you will probably configure SNMP correctly, use a similar configuration on all routers and switches, and then forget the details of how to configure all the other possible options. For the CCNA R&S exams, it helps to

Read Full Article
Answers: Dynamic NAT 1

Answers: Dynamic NAT 1

🕔09:10, 10.Aug 2016 This latest lab asked you to configure dynamic NAT. As always, it is helpful to do the lab first, even on paper or in a text editor. However, this is a great one to try on real gear or with Read Full Article
Dynamic NAT 1

Dynamic NAT 1

🕔09:05, 8.Aug 2016 Dynamic NAT – specifically, dynamic NAT without also doing PAT – creates a 1-to-1 mapping between an inside local address and an inside global address. Unlike static NAT, however, with dynamic NAT the specific IP addresses to map are not Read Full Article
Answers: NTP Client/Server 1

Answers: NTP Client/Server 1

🕔09:10, 1.Aug 2016   Configuring a router to have a split NTP personality is not as bad as it sounds. In this lab, you configure NTP client/server mode, plus a couple of NTP clients, and set the timezone. As usual, read the lab Read Full Article
NTP Client/Server 1

NTP Client/Server 1

🕔09:05, 1.Aug 2016   NTP makes me think of old spy novels and movies, where the team would set their analog watches to the same time, and say something like “On my mark, it will be 9:55… mark!”. NTP uses other mechanisms, of Read Full Article
Answers: SNMPv2c Secured with ACLs

Answers: SNMPv2c Secured with ACLs

🕔13:10, 29.Jul 2016

This latest lab lets you practice configuring SNMP. At the same time, it lets you configure restrictions so that only some devices are allowed to even use SNMP with the routers in the lab. Check out the lab requirements first,

Read Full Article
SNMPv2c Secured with ACLs

SNMPv2c Secured with ACLs

🕔13:05, 28.Jul 2016

#CCNA candidates can struggle with SNMP configuration for a couple of reasons. First, in real life, you configure SNMP on each device and then ignore the configuration. Because of that, when you do have to configure it, most of us

Read Full Article
Answers: PAT w/ a Pool 1

Answers: PAT w/ a Pool 1

🕔09:10, 13.Jul 2016 Configuring #PAT with a pool has it all as far as NAT is concerned. Exercise your memory and skills, and as always, find a place to try it out if you can. (This config may have the command with the Read Full Article
PAT w/ a Pool 1

PAT w/ a Pool 1

🕔09:05, 11.Jul 2016 Configuring #PAT with a pool of inside global addresses combines most everything you can possibly configure with NAT in a Cisco router. Take a look at the requirements in this latest lab and put together your own configuration, with a Read Full Article

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Thank you for subscribing.

Something went wrong.

Search

Categories