Answers: Basic EIGRP

Answers: Basic EIGRP

🕔09:05, 27.Jan 2016

Configure EIGRP, and configure the link delay – and influence the routes in a small lab network. That’s the summary of your task for this most recent lab. Check out the original lab post first, create your own answer, and

Read Full Article
EIGRP and Delay

EIGRP and Delay

🕔09:05, 25.Jan 2016

#EIGRP uses bandwidth and delay as components in its metric calculation by default. This lab uses a design and topology with all gigabit interfaces. The bandwidth part of the calculation uses the slowest bandwidth in a route, so all routes

Read Full Article
Answers: L2 EtherChannel 1

Answers: L2 EtherChannel 1

🕔09:05, 21.Jan 2016

Today’s lab: Check your static EtherChannel config. It’s pretty simple, but worth a quick review. Answers below the fold as usual. And check the original lab post for the lab exercise.

Read Full Article
L2 EtherChannel 1

L2 EtherChannel 1

🕔09:05, 19.Jan 2016

#EtherChannel takes a big step towards improving STP. With two links between switches, but without using EtherChannel, each instance of STP could use only one of the links blocking the other link. With a layer 2 EtherChannel, STP treats the

Read Full Article
Answers: Standard Named ACL 1

Answers: Standard Named ACL 1

🕔12:05, 16.Jan 2016 The previous lab exercise requires you to configure a standard named ACL, but as usual, with a few twists. You need to think outside the box a bit to match the correct range of addresses, and work through the choice Read Full Article
Standard Named ACL 1

Standard Named ACL 1

🕔12:05, 14.Jan 2016 Standard named ACLs follow a nice simple format, which is great for getting started with ACLs. This next lab gives you some exercise on the basic syntax, while throwing in a few issues related to the application of the ACL. Read Full Article
Answers: OSPF Network Config 2

Answers: OSPF Network Config 2

🕔09:05, 13.Jan 2016

Everyone should come to the #CCNA game ready to configure OSPF, with network commands, and with wildcard masks that match entire classful networks, match subnets, and match individual IP addresses. Use today’s post to check your answers. But it’s always

Read Full Article
OSPF Network Config 2

OSPF Network Config 2

🕔09:05, 11.Jan 2016

What if your #CCNA exam required you to configure the OSPF network command with a particular style of mask? What if it said “match all addresses in the subnet”, or “match all addresses in the classful network”? Or even “match

Read Full Article
Answers: Serial Link 1

Answers: Serial Link 1

🕔13:10, 9.Jan 2016 The first key to getting serial links working in a lab is to make sure you have a good understanding of the back-to-back cable, the DCE end of the cable, and two competing commands: the clock rate and bandwidth commands. Read Full Article
Serial Link 1

Serial Link 1

🕔13:10, 7.Jan 2016 Ever set up serial links for your #CCENT or #CCNA lab? Here’s a short lab to get you started with the basics. The lab asks for all the commands required to get the links working, plus a few related commands, Read Full Article

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Thank you for subscribing.

Something went wrong.

Search

Categories